RE: Multi stream UDP test issue
When I run a loop over number of threads sometimes I get up to 4 or 8
threads and than fail and sometimes it fails on single/dual thread
nothing consistent.
So I guess it may be other issue.
Do u have any command line you want me to check ?
When you refer to multi addresses , all my eth devices are in different
subnets so I don't think this should be issue.
-----Original Message-----
From: owner-iperf-users --at-- dast.nlanr.net
[mailto:owner-iperf-users --at-- dast.nlanr.net] On Behalf Of Miika Komu
Sent: Tuesday, December 25, 2007 9:55 PM
To: iperf-users --at-- dast.nlanr.net
Subject: Re: Multi stream UDP test issue
On Mon, 24 Dec 2007, Sagi Rotem wrote:
Hi,
I have noticed that iperf, among other UDP-based applications (such as
nc/nc6), fail when server host has multiple addresses. When the server
has multiple addresses, receives using its address A, but sends back a
response using address B. Now, if A happened to be the default address
of the host, address B usually then equals to A and it actually works.
Otherwise it just fails.
Is this the case also with you? (Probably it is different issue, though)
> Hi,
>
> I am running Iperf 2.0.2 UDP with multi streams Client iperf -c <> -l
> size -u -b 10000M -P <num threads> Server : iperf -s -u sometimes the
> test passes and sometimes i get:
> write2 failed: Connection refused
>
> this does not occur in TCP test.
> Is this a known issue ? any workaround ?
>
> Happy holidays,
> Sagi Rotem
>
>
>
--
Miika Komu
http://www.iki.fi/miika/